A pictoral representation of UIAA-105 and EN-12277 standards for harnesses.
This is an all-rounder climbing harness designed specifically for lead climbers. The well thought out features and its ergonomic design makes this one harness very versatile and suitable for many forms of climbing. This harness features our Lean waist belt. It above normal width but countered and lean design makes for a perfect fit around your waist. This feature was added keeping the route openers in mind who might have to hang in their harnesses for longer durations while bolting a new route.
• Waist belt strength rating: 18kN. For your comparison UIAA’s minimum requirement: 10kN)
• Belay Loop breaking strength: 26kN. UIAA’s minimum requirement is 15kN
• Buckles: Stainless Steel. Breaking strength = 16kN
• the harness is made from BLUESIGN certified breathable and water repellent Sympatex fabric. The fabric is a three layered bonded fabric that is made in Japan.
• Haul Loop on the rear rated at 5kN
• Leg Loops: Elasticated
When you click a link below and then checkout online, no matter what you buy (climbing gear or not), we get a small commission that helps us keep this site up-to-date. Thanks!
In grams, the weight, as stated by the manufacturer/brand.
If there are differences in weight (due to multiple sizes or optional accessories) we'll list them here.
The default weight is the middle-most size, often this is size M.
| 300 g|
|Sizes||S, M, L, XL|
Number of Gear Loops
Gear loops are used to hold gear (quickdraws, cams, etc) onto your harness. 4 gear loops is most common.
0 - 1 Gear Loops
Most often on full body harnesses or guide/gym style harnesses.
2-3 Gear Loops
Mostly found on lighter harnesses made for [ski] mountaineering or high-end sport climbing where weight is a high priority.
4 - 5 Gear Loops
The standard/most common number for climbing harnesses. Perfect for sport and trad.
More Than 6 Gear Loops
Designed for long multi-pitch and big wall climbing, found on harnesses made to hold the maximum amount of gear.
Occasionally, the number of gear loops will change on a harness model depending on the size. There could be 7 gear loops for the med/large but only 5 gear loops for the xsmall/small. In this case we list the highest number for the filters, and then write an explanation on the product page like, “Size S/XS can only fit 5 gear loops.”
|4 Gear loops|
|Ice Clip Slots|
Ice Clip Slot
Ice clipper slots are made to fit a carabiner that holds ice screws. These slots are generally only used by ice climbers but there is no disadvantage to having them on your harness.
Less than 40% of harnesses will have ice clipper slots. And those harnesses will usually have 2 or 4 slots, often located next to, or between, the gear loops.
|Belay / Tie-In||One Loop|
|Waist Buckle Type||Quick Adjust|
|Leg Buckle Type||None (it stretches)|
Trad climbers often look for a haul loop as they're intended to haul a rope (second line) or pack (while you climb the chimney).
A haul loop can also hold shoes or other accessories. Although not the intended use, it is also commonly used to hold a chalk bag.
The UIAA equipment standard provides a baseline for equipment performance in a test lab under controlled conditions on new equipment. Although these test conditions are relevant to the conditions encountered climbing, conditions encountered at the crags and the condition of the equipment are equally important. This recommendation from the UIAA member federation The British Mountaineering Council (BMC) provides vital equipment information that is NOT explicitly addressed in the standard, particularly failure modes of the equipment and recommendations for the use, inspection, maintenance, and retirement of equipment.